国产av高清网站无码

草蜢在线观看免费高清完整版日本

Product catalog
contact us

Delter (Beijing) Technology Co., Ltd

Headquarters Tel: 010-63378109


Headquarters address: room 1205, unit 2, building 6, yard 6, Honglian South Road, Xicheng District, Beijing

Email: Sales ා xnta.cn@

Article details

Ts200 beacon and ultrasonic tester

Date: 2021-12-24 00:59
Views: 112
Abstract: Dukane seacom ts200 is an independent hand-held ultrasonic tester, which can test underwater acoustic beacon. It is a battery driven heterodyne receiver operating at an ultrasonic frequency of 37.5 kHz. The test device can be used to test the operation of Dukane Corporation KD series beacons by using an internal microphone and a loud speaker without removing the beacon from the aircraft bracket. The ts200 ultrasonic tester can also be used for voltage measurement to test the battery power in Dukane seacom's underwater acoustic beacon. The Dukane TS-200 beacon tester is battery powered and easy to use. With a few simple button commands, you can easily test the battery function of the beacon and its operation ability in flight. The tester has an easy to read LCD display. When the beacon is still installed on the fuselage or flight record, ts200 acoustic beacon tester can be used.

Dukane seacom ts200 beacon and ultrasonic tester

News Keywords: Dukane Avionics Positioning beacon tester Dukane Seacom Ts200, ultrasonic tester, TS-200


Ts200 beacon and ultrasonic tester Characteristics and specifications

Dukane Seacom ts200 is an independent handheld functional ultrasonic tester, which can test underwater acoustic beacons. It is a battery driven heterodyne receiver at 37.5 It works at the ultrasonic frequency of kHz. The test device can be applied to Dukane Corporation KD series beacons are tested for operation by using an internal microphone and a loud speaker without removing the beacon from the aircraft bracket. The ts200 ultrasonic tester can also be used for voltage measurement to test Dukane Battery power in seacom's underwater acoustic beacon.

The Dukane TS-200 beacon tester is battery powered and easy to use. With a few simple button commands, you can easily test the battery function of the beacon and its operation ability in flight. The tester has an easy to read LCD display. When the beacon is still installed on the fuselage or flight record, ts200 acoustic beacon tester can be used.

  • Ultrasonic beacon tester
  • Quickly check the battery voltage on dk100, dk120, dk130 and dk140 beacons
  • Battery powered
  • Easily test the battery function of beacon and its operation ability in flight
  • Easy to read LCD
  • It can be used when the beacon is still installed on the fuselage or flight recorder
  • Made in America

  Ts200 beacon and ultrasonic tester
Dimensions 6.5 in. (165.1 mm) H x 3.25 in (82.55mm) w x 1.33 in. (33.78mm) d
weight 17 ounces (485G)
Battery 9 VDC (one section)
Compatible underwater acoustic beacon Dk100 series beacon
Process validation LCD screen reading

Operation steps of ts200 beacon and ultrasonic tester:
A. Turn on the test unit using a small sliding switch located on the left side of the enclosure.
B. If Lb is shown on the display, the ts200 battery voltage has dropped below the level required for the test device to operate, and the 9-volt battery should be replaced. See Maintenance Section 3.2
C. Test beacon voltage. Connect the test probe clamp to the pinger housing.
See Figure 2. The clip has a spring action to slide it over the housing on the light beacon. Contact the probe * * with the silver pad on the white dome at the end of the beacon. The display will show the battery voltage of the beacon. Refer to the appropriate beacon manual for the acceptable range of beacon battery voltage.
D. Operation test. As mentioned above, place the probe on the beacon and press the red button on the ts200 (the test set display will be blank during this operation). The beacon should be activated and a thump from the ts200 can be heard. Note that a high level of background noise may interfere with the test. If you have difficulty hearing the beacon, the operator should repeat the test in a quiet area.


42a12 / 1 beacon tester ultrasonic tester ts200 related products

  • Voice confirmation of beacon operation
  • One handed operation
  • Necessary operational tests were conducted on dk100, dk120, dk130 and dk140 beacons
  • Other beacons in the range of 30-45 kHz
  • It can be used when the beacon is still installed on the fuselage or aircraft flight recorder


草蜢在线观看免费高清完整版日本_小蝌蚪2.0_free日本